Shopping Cart
0 item(s) - $0.00
Your shopping cart is empty!

ECT 246

$5.99

This Tutorial was purchased 2 times & rated B+ by student like you.

ECT 246 ECT/246 ECT 246  Week 1 Homework .....
$5.99

This Tutorial was purchased 0 times & rated No rating by student like you.

TCO #1: Given an application requiring an AC to DC regulated power supply discuss the block diagram of the supply, and how its internal subsystems are related, using the appropriate data sheets, determine the device’s operating parameters, calculate, simulate and measure the power supply’s el.....
$5.99

This Tutorial was purchased 1 times & rated A by student like you.

ECT 246 ECT\246 ECT 246  Week 2 Homework .....
$5.99

This Tutorial was purchased 3 times & rated A+ by student like you.

Part A-Transistor Circuits   TCO #2: Given an application requiring a single-stage common emitter BJT amplifier and a common source JFET amplifier with voltage-divider biasing use the device’s data sheet to establish the operating conditions calculate, simulate, and measure the i.....
$5.99

This Tutorial was purchased 3 times & rated B+ by student like you.

Chapter 22 2) Determine the output polarity for each of the op-amps shown inFigure 22.47. 4) Determine the maximum peak-to-peak output voltage for the amplifier shown inFigure 22.49. 6) The amplifier in Problem 4 has a voltage gain of 220. Determine the maximum allowable peak-to-peak .....
$5.99

This Tutorial was purchased 2 times & rated A+ by student like you.

Part A-Op Amps   TCO #3: Given an operational amplifier (op-amp) circuit schematic, calculate, simulate and measure the input and output voltages, impedance, and signal gain for a inverting, non-inverting, and voltage follower op-amp configurations. A. Define the basic c.....
$6.99

This Tutorial was purchased 1 times & rated No rating by student like you.

ECT 246 ECT/246 ECT 246  Week 4 Homework .....
$6.99

This Tutorial was purchased 1 times & rated B+ by student like you.

Part A: Audio Amps TCO #4: Given an audio amplifier application that uses an integrated amplifier, examine the overall amplifier’s performance and verify the operation by using suitable input and output circuits. .....
$6.99

This Tutorial was purchased 3 times & rated A by student like you.

ECT 246 ECT/246 ECT 246  Week 5 Homework .....
$6.99

This Tutorial was purchased 2 times & rated A+ by student like you.

In week five, you will create several circuits using the operation amplifiers you studied earlier. An op-amp can be configured to perform special applications found in everyday electronic equipment. These include comparators, level detectors, summing amplifiers and digital to analog converters. .....
$6.99

This Tutorial was purchased 3 times & rated B+ by student like you.

ECT 246 ECT/246 ECT 246  Week 6 Homework .....
$6.99

This Tutorial was purchased 1 times & rated A by student like you.

Part A-Active Filters Week six addresses the concept of active filters and oscillators. The low, high, bandpass and notch active filters, their circuits, and operating parameters are covered. The Wein-bridge RC oscillator, its configuration, operation and circuit is discussed. TCO #6: .....
$6.99

This Tutorial was purchased 0 times & rated No rating by student like you.

ECT 246 ECT/246 ECT 246  Week 7 Homework .....
$6.99

This Tutorial was purchased 1 times & rated A by student like you.

ECT 246 ECT\246 ECT 246  Week 7 iLab 7 .....
$6.99

This Tutorial was purchased 2 times & rated B+ by student like you.

TCO #8: Given a DC switching application such as driving a motor in one and two directions use a SCR and a transistor and an H-bridge driver to successfully perform the operation, calculate and measure the operating voltages and currents.   Part B-Optical Devices   T.....
$5.99

This Tutorial was purchased 2 times & rated B+ by student like you.

ECT 246 Week 1 Quiz .....
$5.99

This Tutorial was purchased 1 times & rated A by student like you.

1. TCO 1) What is the frequency of the ripple voltage for a full-wave rectifier with an input of 20 Vrms, 60 Hz? 2. (TCO 1) As the AC voltage at the transformer primary decreases, the peak voltage out of the diode bridge will 3. (TCO 1) If a diode on the diode bridge opens,.....
$6.99

This Tutorial was purchased 3 times & rated A+ by student like you.

1. (TCO 5) If Va = 3V, what is Vout? 2. (TCO 3) If Vin = 1V, and Rload = 1k ohm, what is the current through Rload? 3. (TCO 4) If an audio amplifier integrated circuit uses a dual power supply of +/- 30V for the power supply, will there be a capacitor on the output of the a.....
snaptutorial © 2019
Powered By Snap Tutorial